PDA

Archiv verlassen und diese Seite im Standarddesign anzeigen : Latex-File-Fehler-Such-Thread



fabske
12-07-2007, 11:03
Momentan hab ich mal wieder ein Latexfile, welches einen Fehler hat den ich nicht finde. Ich arbeitete eine ganze Menge daran und wenn ich nun PDFLatex mache meldet er einen Fehler, welcher glaube ich nicht die wahre Ursache ist. Ich finde einfach nicht heraus was schief ging und bitte um Unterstützung:
www.intrudix.de/mai-fi.tex

Vielleicht haben ja andere ab und an auch ein solches Problem und können diesen Thread dazu benutzen.

countbela666
12-07-2007, 11:28
Hallo, Fabian,

mit folgenden Änderungen kann ich die Datei kompilieren:

\documentclass[demo,a4paper,titlepage,12pt]{scrartcl} % demo, da ich deine Bilder nicht habe

...

\hspace*{2cm}
\begin{center}
\includegraphics[width=400px,keepaspectratio]{attachments/InterBN.png}
\end{center}\vspace*{2cm}

An easier way is to use the allready existent masts for electricity lines on the roofes of the MAI buildings. You can add a thin light firbe optic calbe on the masts to connect two buildings in each case.

...

I assume to use 802.11a and the allowed 19 channels of the ETSI regulation, although I don't know the exactly what it is in Russia. In case of doubt the channels can be changed:

\begin{tabular}{l|l}
Channel ID & frequency (GHz) \\
36 & 5,180 \\
40 & 5,200 \\
44 & 5,220 \\
48 & 5,240 \\
52 & 5,260 \\
56 & 5,280 \\
60 & 5,300 \\
64 & 5,320 \\
100 & 5,500 \\
104 & 5,520 \\
108 & 5,540 \\
112 & 5,560 \\
116 & 5,580 \\
120 & 5,600 \\
124 & 5,620 \\
128 & 5,640 \\
132 & 5,660 \\
136 & 5,680 \\
140 & 5,700
\end{tabular}

I propose to use RouterBOARD devices, because they are not expensive and open hardware platforms, so you can install free software like OpenWRT on them. In addition the RouterBOARD devices are very flexible and modular to use. You can set them up with various numbers of interfaces you really need

...
Grüße
Marcel

fabske
12-07-2007, 13:56
scheint zu klappen, Danke :)

bischi
12-07-2007, 14:07
btw: already wird mit einem l geschrieben...

MfG Bischi